Search results

  1. W

    Getting in on the fun

  2. W

    Where Have All the Cabovers Gone???

  3. W

    Where Have All the Cabovers Gone???

    I always liked tagging along with Pop, when he drove his truck which was similar to this one.
  4. W

    Getting in on the fun

    we call this one "MiniMe" Whitteys little brother...LOL 2001 International 4900, DT466 with 6plus trans, air brake, double stacked rear springs with locking diff. two 30,000 lb winches and 25ton boom, 20000lb under lift.
  5. W

    Getting in on the fun

    this is the only picture of Big Al I have found on my computer, I know I have a few shots of me at the controls....just can't find them
  6. W

    Getting in on the fun

    Towed in a fellow Tow company rig for us to fix
  7. W

    Overhead Procedures for L10E Cummins

    this is the setting sequence for L10 non-celect.
  8. W

    Overhead Procedures for L10E Cummins

    Ok, for starters this engine should be an external damper L10 and there should be marks "A", "B" and "C" on the face of the accessory drive pulley. like in this picture.
  9. W

    New Kid On The Block

    This is my Rig, well it belongs to the company, but I run it....LOL 1987 International Eagle, 400 Cummins, 13 speed.
  10. W

    New Kid On The Block

    Hi Everyone, I'm not much for talking about myself, but I thought I would give a brief introduction. I have been in the Auto/Truck Repair industry for a little over 30 years. Currently ASE Certified Master in Auto/Truck, Master Medium/Heavy Truck as well...I hold a few certifications in...
  11. W

    3406B inframe I finished back in November

    The unhappy Peterbilt I have a video of the running complete, just can't seem to locate it at the moment.
  12. W

    3306 will not start after remaned injection pump installed

    The broken pieces were preventing the timing from maintaining postion when the engine was cranked over, varing by as much as 30 degrees. All better now.
  13. W

    3306 will not start after remaned injection pump installed

    followed all the directions in the manual, will not start. I do get some smoke out the stack, but it doesn't even try to fire/kick. Anyone have a suggestion or trick I could employ?
Top