This is my first post on here. Want to thank in advance for any replies.
Truck is a 2004 international 4300 with a pre egr dt466e. Was purchased through richie brothers auction up here in edmonton alberta back in september. Drove through the auction ring.
Then buyer never payed for it and was put back in auction for october where it was listed as inoperable (would not start). Between september and october truck accumulated 7km and 5hr on the cluster.
Now that i purchased it. We towed it back to the shop. Traced wiring had ecm tested. all seems fine. however we cannot connect to diagnostics using mac scan tool. truck of course does not start.
So far we have tested relays and fuses in engine bay. traced b+ wiring to ecm from battery and relays aswell as from fuse. (pins 1, 2, 21, 22, and 41) We also tested for continuity between diagnostics port and ecm connector. all is well.
gage cluster does its sweep. Took ecm out and had international test it. they were able to connect and read it with no issues.
Any ideas are of great help.
Truck is a 2004 international 4300 with a pre egr dt466e. Was purchased through richie brothers auction up here in edmonton alberta back in september. Drove through the auction ring.
Then buyer never payed for it and was put back in auction for october where it was listed as inoperable (would not start). Between september and october truck accumulated 7km and 5hr on the cluster.
Now that i purchased it. We towed it back to the shop. Traced wiring had ecm tested. all seems fine. however we cannot connect to diagnostics using mac scan tool. truck of course does not start.
So far we have tested relays and fuses in engine bay. traced b+ wiring to ecm from battery and relays aswell as from fuse. (pins 1, 2, 21, 22, and 41) We also tested for continuity between diagnostics port and ecm connector. all is well.
gage cluster does its sweep. Took ecm out and had international test it. they were able to connect and read it with no issues.
Any ideas are of great help.